Technology 2017-05-05T23:34:25+00:00

MySwing Professional Technology
the only wireless, full-body, motion capture tool for golf professionals that can be used both indoors and out

or call (480) 247-2144
for more information

The Sensors

The MySwing Professional system contains 17 lightweight body sensors and two shaft sensors that seat in a protective case that doubles as a charging device for all of the sensors simultaneously. The sensors are able to capture the motion data, which is transmitted wirelessly to a tablet where it is stored to be analyzed.

The Software

MySwing Professional software is designed to work on any Windows-based tablet or PC. Your FlightScope or Trackman launch monitor data can be captured along with your 3D swing data in MySwing Professional software. All captured data is uploaded to MyLocker, a cloud-based service where you can store and access swings for ongoing analysis and comparison.

About The System

The Case

Protective carrying case
Charging dock
Seventeen body sensors with straps & clips
Two shaft sensors
Receiver/antenna
Charging cord with transformer
Quick start guide
MySwing Professional software
All software, sensor, and hardware upgrades during the term of your service agreement. Your system will always be state-of-the-art.
Yes. It is safe to carry on an airplane and will fit in the overhead compartment.
The dimensions are approximately 17″ x 12″ x 7″.
The weight is under 20 pounds.

The Sensors

To turn on, hold the button for 2 seconds.
Individual sensors can be turned off by holding the button for 5 seconds, or all of them can be turned off simultaneously from the tablet.
To reset a sensor, turn on, then hold the button for 10 seconds (Sensor must be fully recharged after reset).
Slow Blink (Standby)
Fast Blink (Working)
Double Blink every 3 seconds (Sleep Mode)
Blinking Red LED (Indicates Low Battery – approximately 20 minutes remaining)
Constant Red Light- Sensor charging successfully or Sensor Error (please reset sensor)
All systems have 5 available frequencies, with each frequency having a different color LED. Each system must be on a separate frequency to prevent interference.
No, each sensor is designed for a specific part of the body. If the avatar is distorted, check all the sensors to make sure they are placed correctly on the body.
The sensors are not waterproof, but they are water resistant.
The sensors will run continuously for approximately 4 hours.
A full charge takes approximately 45 minutes.

The Straps

Yes. Velcro straps are washable (Remove plastic base).
Yes. The straps are adjustable and come in three different sizes.
To attach a sensor, place it into the plastic base and rotate it 90 degrees counter-clockwise. Handle the sensor gently, do not over tighten.
There are a combination of small, medium, and large straps as well as 1 pelvis strap and 1 shoulder harness.

The Software

In order to create an accurate avatar of the student, both height and wingspan need to be measured before recording a swing.
Yes. For a swing to be recorded each student must agree to the Terms of Use.
Please refer to help tab in the MySwing Professional software.